关于表面处理专业词汇的中英文对照.docx
《关于表面处理专业词汇的中英文对照.docx》由会员分享,可在线阅读,更多相关《关于表面处理专业词汇的中英文对照.docx(14页珍藏版)》请在冰豆网上搜索。
阳极氧化anodic oxidation)
阳极酸化处理 anodizing (英),anodising (美)
阳极酸化皮膜 anodic oxide coating,anodic oxide film
自然酸化natural oxidation
阳极酸化涂装复合皮膜combined coating of anodic oxide and organic films化学氧化膜chemical conversion coatingconversion coating
电解electrolysis
电解液electrolytic solution
阳极anode
阴极cathode
辅助电极auxiliary electrode
极间距离distance between electrodes,anode-cathode distance
电解电压bath voltage
电流密度current density
电流分布current distribution
皮膜产生率coating ratio
活性化处理activation
去离子水deionizer water
散射diffuse reflection
镜面反射mirror reflection specula reflection
反射率reflectivity reflectance
光泽gloss
面光泽度relative-specula glossiness
色差color difference
灰度grey scale
研磨材abrasive
染料dye dyestuff
水溶性染料water soluble dye
油溶性染料oil soluble dye
治具jig,rack
电解框frame for racking
前处理pretreatment
梨地处理mat(matt)finish
环形加工spin finish
发丝hair-line finish
Diamond-cut finish;
光泽处理退光bright finish,bright dipping
研磨sanding,grinding,polishing
皮带研磨belt sanding,belt grinding,belt polishing
振动研磨barrel polishing,barreling,tumbling
电解研磨electrolytic polishing
化学研磨chemical polishing,chemical brightening!
脱脂degreasing
碱蚀alkaline degreasing
酸脱脂acid degreasing
有机溶剂脱脂organic solvent degreasing
乳胶脱脂emulsion degreasing
电解蚀刻electrolytic etching
中和demitting
直流法direct current anodizing
交流法alternating current anodizing
交直重叠法process of superimposed direct current on alternating current
定电流法constant current anodizing
定电压法constant voltage anodizing
草酸皮膜oxalic acid anodic oxide coating
硫酸皮膜sulphoacid anodic oxide coating
硬质皮膜hard anodic oxide coating
原色皮膜self-color anodic oxide coating,integral color anodic oxide coating:
电解染色皮膜electrolytic colored anodic oxide coating
多孔质皮膜porous anodic oxide film
阻挡层膜barrier layer anodic oxide coating
功能皮膜 functional coating
膜flexible anodic oxide
喷雾染色spray dyeing
涂布染色daub dyeing
菲林法photo-printing
印刷染色法direct printing
转写染色法heat transfer printing
脱膜removing of coating,stripping of coating
封孔处理sealing of anodic oxide coating
水合封孔处理hydro-thermal sealing
水蒸气封孔处理steam sealing
热水封孔处理boiling water sealing
镍盐封孔处理nickel sealing.
化学氧化处理boehmite process'
电解涂装electrodeposition coating,electrophoretic coating
磷酸盐法phosphate process(
皮膜单元oxide cell
多孔质层porous layer
一水合氧化铝boehmite
皮膜厚度coating thickness
表面粗度surface roughness
皮膜均一性uniformity of film'
皮膜表面密度apparent density of film
皮膜质量coating mass
阳极酸化皮膜的固化ageing
皮膜烧焦burning of anodic oxide coating
皮膜破坏cracking of anodic oxide coating,crazing of anodic oxide coating,stress cracking阳极粉化blooming
挂灰sealing smut"
风化weathering bloom
干涉色iridescence;
孔腐蚀pitting corrosion;
局部腐蚀local corrosion
系状腐蚀filiform corrosion
接触腐蚀galvanic corrosion
耐侯性weather resistance
耐腐蚀性corrosion resistance
耐磨性abrasion resistance,wear resistance)
耐污染性stain resistance
写像性image clarity'
光泽brightness
色堅度color fastness:
脱离耐力dielectric strength
击穿电压breakdown voltage
色匹配度color matching
色的许容差color tolerance
皮膜厚試験coating thickness test
盐雾试验salt spray test
盐雾试验copper accelerated acetic acid salt spray test(CASS test)
耐碱试验alkali resistance test
封孔试验sealing test
皮膜硬度试验hardness test of anodic oxide coating
耐磨耗性试验abrasion resistance test,
光堅ろう度试验accelerated light fastness test
色差计color-difference meter
屋外曝晒试验outdoor-exposure tes
加速耐候性试验accelerated weathering test
1表面预处理
1.1光亮化brightening
用化学或电化学抛光的方法,使金属表面光亮的过程。
1.2光亮浸渍bright dipping
金属在溶液中浸渍后,使金属表面光亮。
1.3抛光polishing
减小金属表面粗糙度的过程。
1.4软轮磨光buffing
金属表面通过旋转的软轮进行抛光。
轮上所用的磨料为含有细小研磨颗粒的悬浊液、膏体或粘性油脂。
1.5电解光亮化electrobrightening
用适当的电解处理方法使金属表面光亮化
1.6电解抛光exechtropolishing
在适当的电解液中作为阳极的抛光处理。
1.7电解浸蚀electrolytic etching
铝在适当的溶液中用电解法所进行的浸蚀。
1.8化学光亮化chemical brightening
铝浸入溶液中使其表面光亮化的处理。
1.9化学抛光chemical polishing
铝浸入化学溶液中抛光处理。
1.10脱脂degreasing
用机械、化学或电解方法除去表面的油脂。
1.11酸洗pickling
通过化学作用
(一般在酸里),除去铝表面的氧化物或其他化合物。
1.12清洗cleaning
用弱酸、弱碱溶液、溶剂及其蒸气,清除表面油脂和污垢的处理方法。
这种处理可以采用化学或电解法。
1.13除灰desmutting
除去附着在铝表面上的灰状物(例如:
铝在碱洗之后再浸入硝酸溶液中的处理 ,俗称出光)。
1.14去氧化物处理deoxidizing
除去表面的氧化物。
1.15浸蚀etching,etch
金属材料的表面在酸性或碱性溶液中,由于表面全部或局部溶解使其粗糙化。
酸浸蚀过程可以在通电或不通电的条件下进行。
这种方法也可用于电解电容器铝箔、印刷电路板和装饰性结构等特殊生产工艺。
1.16刷光brushing
表面进行机械清理的一种方法,通常用旋转的刷子。
1.17磨光grinding
采用附着在刚性或柔性物体上的磨料去除表层物质的过程。
1.18带式磨光belt grinding,belt polishing
一种机械处理铝件的方法。
铝件与粘有磨料的环形条带磨擦接触。
1.19滚筒磨光tumbling
为改善金属表面的光洁度,在滚筒中(有无磨料弹丸均可)批量处理铝件的过程。
1.20喷磨abrasive blasting
用空气流将刚玉或玻璃砂射向物体表面和处理方法。
也可采用悬浮在水或其他液体中的细小磨料进行喷磨(湿喷或蒸喷)。
1.21喷丸shot blasting
向金属表面喷射硬而小的球状物(如金属丸)的处理方法。
1.22喷玻璃丸处理glass bead blasting
将细小的球状玻璃丸喷射在金属表面,使其表面得到清洁或硬化的处理方法。
1.23喷砂sand blasting
用砂或氧化铝进行喷磨。
1.24湿喷wet blasting,liquid honing
将含有磨料的水浆以高速向工件喷射,对其表面进行清洗或精加工。
1.25活化activation
表面由钝态向活化态的转变。
1.26再活化reactivation (of an anodic oxide coating)
阳极氧化膜经酸处理后,吸附染料能国增加的现象。
1.27脱膜stripping
用适当的化学溶液除去金属表面层的阳极氧化膜。
2阳极氧化与化学氧化
2.1阳极氧化anodizing,anodic oxidation
电解氧化过程。
在该过程中铝或铝合金的表面通常转化成一层氧化膜,该膜具有防护性、装饰性及一些其他功能特性。
2.2阳极anode
2.2.1在电解过程中,使负离子放电,生成正离子或发生其他氧化反应的电极。
2.2.2能够起到上述作用的物体。
2.3阴极cathode
2.3.1在电解过程中,使正离子放电,生成负离子或发生其它还原反应的电极。
2.3.2能够起到上述作用的物体。
2.