1、marketing strict internal cost control, business and innovation performance. -Increasing electricity access, price increase, electricity supply is guaranteed. In 2012, the company with coal inventory, get rewards of Jiangsu provincial government power to 266 million kWh. Through the small and bilate
2、ral trade, access to electricity 1.695 billion kWh, seeking removal compensation when the power 50 million-kilowatt, 116% market share in Jiangsu Province ranked first in the same capacity, the same type units. Company closely tracked coal linkage policies on July 1 and August 20 respectively increa
3、se prices 2.08 minutes and 2.5 points, profitability increased significantly. 公 . Job grading, remuneration of labour agreements into long-term contract workers compensation system, stimulating the enthusiasm of the staff. -Further strengthening of human resources management. Full implementation of
4、the performance appraisal regulations, incentive effect. Complete the reserve cadre evaluation and selection, produced 10 primary reserve cadres and 11 secondary reserve cadres. Implementation of operation staff induction gang system, 14 staff posts be promoted. Strengthening the cultivation of prof
5、essional technical leaders, selected coverage 9 13 factory-level professional and technical leaders. To enhance staff skills training, 8 staff technicians. Labor contract law compliance, contracts of up to 100%. -Star team-building to advance further. Establish a holding system implementation, and p
6、romoting the whole team-building goals, strengthen group management. Team building into a performance review, promoting the construction of the star team depth. This year, respectively, 1 track, 4 team four star rated five-star by Datang and the team. Four, insists on six cultural construction of ha
7、rmonious development, really good job of party construction and the independent Commission against corruption, strengthening the humanistic care and psychological counseling, the enterprise culture construction to a new level. -Building of enterprise culture is fruitful. Companies adhere to the Shen
8、hua lead of corporate culture, culture of responsibility at the core, to safety culture, a culture of learning, ethical culture, cost culture culture system-assisted, through various cultural integration, has boosted business centre, this year has won the Chinese cultural management advanced unit, N
9、ational Advanced Unit in the building of enterprise culture of reform and opening up 30 and other honorary titles. The liability of the company culture: solving management problems of corporate culture project was awarded the CEC national electric power enterprise culture achievement award of excell
10、ence. The accident early warning and prevention system was rated as Chinas power of innovation management, innovation management of electric power enterprise in Jiangsu Province. -Party and the independent Commission against corruption continues to strengthen. Was carried out to maintain建筑工程消防设施施工及验
11、收规范(防排烟系统篇)1.1 设备及配件进场1.1.1 一般规定1 主要设备应有装箱清单、设备说明书、产品质量合格证书和产品性能检测报告等随机文件,进口设备还应具有商检合格的证明文件。所有产品的型号、规格均应符合设计要求。2 设备安装前,应进行开箱检查,并形成验收文字记录。参加人员为建设、监理、施工和厂商等方单位的代表。3 设备就位前应对其基础进行验收,合格后方能安装。4 设备的搬运和吊装必须符合产品说明书的有关规定,并应做好设备的保护工作,防止因搬运或吊装而造成设备损伤。1.1.2 风 管1 普通风管的材料品种、规格、性能与厚度等应符合设计和现行国家产品标准的规定。金属风管的钢板或镀锌钢板的
12、厚度不得小于表7.1.2的规定。表1.1.2 钢板风管板材厚度(mm)风管直径或长边尺寸b送风系统排烟系统b3200.50.8320b4500.60.8450b6300.60.8630b10000.81.01000b12501.01.01250b20001.01.22000b40001.2按设计检查数量:按材料与风管加工批数量抽查10%,不得少于5件。检查方法:查验材料质量合格证明文件、性能检测报告,尺量、观察检查。2 防火风管的材料品种、规格、性能与厚度等应符合设计和现行国家产品标准的规定;风管的本体、框架与固定材料、密封材料等必须为不燃材料,耐火极限应符合设计的规定。检查数量:按材料与风管
13、加工批数量抽查10%,不得少于5件。检查方法:查验材料质量合格证明文件、性能检测报告,观察检查。1.1.3 风管部件1 防火阀和排烟防火阀必须符合产品标准的规定,并具有相应的产品合格证明文件。检查数量:按种类、批抽查10%,不得少于个。检查方法:核对产品的合格证明文件、性能检测报告。2 电动的防火阀、排烟防火阀、排烟口和送风口的驱动装置,动作应可靠。检查数量:按批抽查10%,不得少于1个。检查方法:核对产品的合格证明文件、性能检测报告、观察或测试。1.1.4 风机1 防、排烟风机必须符合产品标准的规定,并具有相应的产品合格证明文件。检查数量:全数检查。检查方法:核对产品的合格证明文件、性能检测
14、报告。1.1.5 其他附件1 挡烟垂壁应采用不燃材料或难燃材料制作,活动挡烟垂壁的驱动装置动作应可靠。检查数量:按批抽查10%,不得少于1个。检查方法:核对产品的合格证明文件、性能检测报告、观察或测试。2 电动的排烟窗的驱动装置动作应可靠。检查数量:按批抽查10%,不得少于1个。检查方法:核对产品的合格证明文件、性能检测报告、观察或测试。1.2 防、排烟系统的施工1.2.1 一般规定1 防、排烟系统的施工应严格按照设计图纸施工,并制定必要的施工方案,施工图纸修改应有设计单位的变更通知书或技术核定签证。2 承担防、排烟系统工程项目的施工企业,应具有相应的工程施工承包资质及相应的质量管理体系。3
15、防、排烟系统的设备安装,应符合其产品说明书的有关要求。1.2.2 管道系统的施工1 对风管制作质量的验收,应按其材料、系统类别和使用场所的不同分别进行,主要包括材质、规格、强度、严密性与成品外观质量等项内容。2 管道系统安装完毕后,按系统类别进行严密性检验,检验以主、干管道为主。其强度和严密性要求应符合设计或下列规定:1) 风管的强度应能满足在1.5倍工作压力下接缝处无开裂;2) 风管的允许漏风量,应符合以下规定:低压系统风管 QL0.1056 P0.65 m3/(h)中压系统风管 QM0.0352 P0.65 m3/(h)排烟管道均按中压系统的规定。式中:QL ,QM 系统风管在相应工作压力下,单位面积风管单位时间内的允许漏风量m3/(hm2);P 指风管系统的工作压力(Pa),风管系统按其系统的工作压力划分为三个类别,见表7.2.2,其中防、排烟系统为低压、中压系统。表1.2.2 风管系统类别划分系统类别系统工作压力P(Pa)低压系统P500中压系统50015003) 砖、混凝土风道的允许漏风量不应大于矩形风管规定值的1.5倍;4) 低压系统的严密性检验可采用漏光法检测,检测不合格时,作漏风量测试;中压系统应在漏光法检测合格后,作漏风量测
copyright@ 2008-2022 冰豆网网站版权所有
经营许可证编号:鄂ICP备2022015515号-1