药物合成反应课后翻译Word文档格式.docx

1、2-Methyl-4-ethoxalylcyclopentane-1,3,5-trione. A solution of sodium ethoxide is prepared in a 2-l. three-necked, round-bottomed flask fitted with a mercury-sealed stirrer, a reflux condenser carrying a drying tube, and a stopper by the addition of 69.0 g. （3 moles） of sodium to 950 ml. of absolute e

2、thanol. 69.0g（3mol）钠和950ml无水乙醇在配有干燥回流冷凝管和汞封搅拌器的2L三口圆底烧瓶中制备乙醇钠。The solution is cooled to 05 in an ice bath and stirred.溶液在0-5下冰浴搅拌。 The stopper is replaced by a dropping funnel, and a cold mixture （515） of 108 g. （1.50 moles） of freshly distilled 2-butanone and 482 g. （3.30 moles） of diethyl oxalate

3、（Note 1） is added gradually over a period of 30 minutes.瓶塞用分液漏斗取代，108g（1.5mol）的丁二酮和482g（3.3mol）的乙二酸二乙酯在5-15下低温混合，在30分钟内逐步滴加到溶液中。 After the addition is complete, the thick, orange-red mixture is allowed to warm with continued stirring to room temperature, heated under reflux for 30 minutes, and coole

4、d again to 0 in an ice bath. 完全加入后，橘红色的粘稠物继续搅拌至室温，加热回流30分钟后在冰浴中冷却至0。The mixture is decomposed by stirring with 165 ml. of sulfuric acid （1:1 by volume） added in portions.将165ml浓硫酸（体积比1:1）在搅拌加入，分解混合物。 The sodium sulfate formed is filtered by suction and washed with ethanol （150200 ml.） （Note 2）. 硫酸钠抽

5、滤后用乙醇（150200 ml）洗涤。The washings and filtrate are combined and concentrated by evaporation .合并滤液和洗涤液后蒸发浓缩。The yellowish brown product which accumulates by slow crystallization is collected by filtration, washed with small quantities of ice-cold water, and dried in air. 过滤缓慢析出的棕黄色产品用小剂量的冰水洗涤后在空气中干燥。 T

6、he crude product weighs 140150 g.粗产品140-150g。 Further evaporative concentration of the mother liquor followed by cooling furnishes an additional 4050 g. of the keto ester, 此外将母液用冷冻蒸发浓缩后又得到40-50g的酮酯。bringing the total yield to 180200 g. （5359%）产品总共180-200g（产率53-59%） （Note 2）. This crude material （m.p

7、. 120130） is used in the next step.粗品（熔点120130）用于下一步中 A pure sample can be obtained by crystallization from ethyl acetate after treatment with Norit activated carbon, m.p. 160162.纯品是经过活性炭处理后在乙酸乙酯中结晶得到，熔点160162。The procedure for 2- pyrrolealdehyde 2-吡咯甲醛In a 3-l. three-necked round-bottomed flask, fi

8、tted with a sealed stirrer, a dropping funnel, and a reflux condenser, is placed 80 g. （1.1 moles） of dimethylformamide （Note 1）.在配有封闭搅拌器、滴液漏斗和冷凝回流装置的三口圆底烧瓶中放入80g（1.1mol）的二甲基甲酰胺。 The flask is immersed in an ice bath, and the internal temperature is maintained at 1020, while 169 g. （1.1 moles） of pho

9、sphorus oxychloride is added through the dropping funnel over a period of 15 minutes. 烧瓶浸入冰浴中，内部温度保持在10-20，169g（1.1mol）的磷酰氯通过滴液漏斗在15分钟内滴加。An exothermic reaction occurs with the formation of the phosphorus oxychloride - dimethylformamide complex. 放热反应生成磷酰氯二甲基甲酰胺化合物。The ice bath is removed, and the mi

10、xture is stirred for 15 minutes （Note 2）. 移去冰浴，在搅拌15分钟。The ice bath is replaced, and 250 ml. of ethylene dichloride is added to the mixture. 重新再冰浴下加入250ml的二氯乙烯。When the internal temperature has been lowered to 5, a solution of 67 g. （1.0 mole） of freshly distilled pyrrole in 250 ml. of ethylene dich

11、loride is added through a clean dropping funnel to the stirred, cooled mixture over a period of 1 hour. 当内部温度降到5度时，把67g（1.0mol）新蒸馏的吡咯加入到250二氯乙烯中，通过滴液漏斗在1小时内低温下边搅拌边滴加。After the addition is complete, the ice bath is replaced with a heating mantle, and the mixture is stirred at the reflux temperature f

12、or 15 minutes, during which time there is copious evolution of hydrogen chloride.滴加完后，用加热装置取代冰浴，搅拌回流15分钟， 直到有大量氯化氢产生。The mixture is then cooled to 2530, and to it is added through the dropping funnel a solution of 750 g. （5.5 moles） of sodium acetate trihydrate （Note 3） in about of water, cautiously

13、 at first, then as rapidly as possible. 当混合物降温到25-30后，通过滴液漏斗加入750g（5.5mol）的三水醋酸钠溶液，开始要小心，然后要尽可能地快。The reaction mixture is again refluxed for 15 minutes, vigorous stirring being maintained all the while （Note 4）. 反应物在充分搅拌下重新回流15分钟。The cooled mixture is transferred to a 3-l. separatory funnel, and the

14、 ethylene dichloride layer is removed. 冷却的混合物转移到分液漏斗中，出去二氯乙烯层。The aqueous phase is extracted three times with a total of about 500 ml. of ether. 水相用500ml乙醚分三次萃取。The ether and ethylene chloride solutions are combined and washed with three 100-ml. portions of saturated aqueous sodium carbonate solutio

15、n, which is added cautiously at first to avoid too rapid evolution of carbon dioxide.合并乙醚和氯乙烯溶液，用100ml饱和碳酸钠溶液分三次洗涤，然后通入二氧化碳，通入时要小心不要太快。 The non- aqueous solution is then dried over anhydrous sodium carbonate, the solvents are distilled, and the remaining liquid is transferred to a Claisen flask and

16、distilled from an oil bath under reduced pressure （Note 5）. 非水溶液用无水碳酸钠干燥，蒸馏溶剂，余下的溶液移入克氏烧瓶在油浴中减压蒸馏。The aldehyde boils at 78 at 2 mm.; there is very little fore-run and very little residue. 醛沸点78度在2mm；很少有预留无和残渣。The yield of crude 2-pyrrolealdehyde is 8590 g. （8995%）, as an almost water-white liquid which soon crystallizes. 当几乎透明的液体会马上结晶，粗品产量85-90g（89-95%）。A sample dried on a clay plate melts at 3540. 样品在素烧瓷板上干燥