机动车顶棚设计指南.docx
《机动车顶棚设计指南.docx》由会员分享，可在线阅读，更多相关《机动车顶棚设计指南.docx（15页珍藏版）》请在冰豆网上搜索。
机动车顶棚设计指南
目次
前言······················································I
范围······················································1
1简要说明···············································1
2设计构想···············································2
2.1人机工程分析··········································3
2.2间隙、台阶、公差分析····································3
2.3制造工艺可行性分析····································5
2.4装配工艺可行性分析····································5
2.5紧固方式··············································6
2.6风险分析··············································6
2.7主要性能要求··········································7
3顶棚的结构及材料类型···································7
3.1常用材料··············································7
3.2加工工艺··············································7
4失效模式···············································7
附录A（资料性附录）猎豹CP2顶棚总成图····················································8
附录B（资料性附录）猎豹CS6顶棚总成图·······················································9
附录C（资料性附录）猎豹CS7顶棚总成图······················································10
附录D（资料性附录）PAJEROCK顶棚总成图··················································11
参考文献··················································································12
前言
本标准由湖南长丰汽车内装饰有限公司设计部提出。
本标准由湖南长丰汽车内装饰有限公司设计部归口。
本标准起草单位：
湖南长丰汽车内装饰有限公司设计部。
本标准主要起草人：
本标准标准化审查人：
本标准审核人：
本标准批准人：
汽车内饰顶棚设计规范
范围:
本标准规定了汽车内饰顶棚在开发设计过程中应遵守的一些要求和标准，规定了汽车内饰顶棚开发的一般过程、材料选择、内饰顶棚成品规范等。
本标准适用于公司开发越野车及轿车内顶棚的设计
6．顶棚和遮阳板的配合
2.5紧固方式
顶棚后部一般用3个塑料卡扣固定,前部用遮阳板的固定座固定,如果后部有顶灯的可以通过顶灯固定.如果没有可以用2-3个塑料卡扣固定,周围用乘客扶手固定.
2.6风险分析
附录A
（资料性附录）
猎豹CP2顶棚总成图
CP2普通顶棚
CP2天窗顶棚
附录B
（资料性附录）
猎豹CS6顶棚总成图
CS6天窗顶棚
CS6标准顶棚
附录C
（资料性附录）
猎豹CS7顶棚总成图
CS7标准顶棚
CS7天窗顶棚
附录D
（资料性附录）
PAJEROCK顶棚总成图
PAJEROCK标准顶棚
PAJEROCK天窗顶棚
升级会员 