焚烧炉操作说明Word格式.docx
《焚烧炉操作说明Word格式.docx》由会员分享,可在线阅读,更多相关《焚烧炉操作说明Word格式.docx(2页珍藏版)》请在冰豆网上搜索。
2.将柴油“置换”开关置于“正常”位。
3.点火油头开关(辅助)放于“正常”位。
4.把所有“手动”放于“自动”位。
5.把废油压力调节阀和流量调节阀全开。
6.打开电源开关,打开雾化空气阀等。
7.按下“复位”开关。
8.按下“自动启动”开关。
9.排烟风机和废油泵将运转,调节废油压力至0.06MPa。
10.废油开始燃烧后,调节废油流量,控制炉膛温度900~950℃
11.当需要停止时,按下“自动停止”按钮。
要停止前,需用轻油置换废油。
当炉膛温度低于50℃时,排烟风机自动停止。
12.关闭相关阀门。
OPERATIONOFINCINERATOR
Methodofincineratingwasteoil
1.Heatingwasteoiltankupto60℃,Openthewasteoiltankoutletvalveandpilotburnerdieseloilinletvalve.
2.Putthedieseloilsubstitutionswitchin“Nor.”Position.
3.Putthepilotburnerswitch(Assist)in“Nor.”position.
4.PutallmanualoperationswitchesinAutoposition.
5.Putthewasteoilpressureregulatingvalveandwasteoilflowregulatingvalveinfullopenposition.
6.Turnonpowerswitch,Openmainvalveasatomizingairmainvalveetc.
7.Presstheresetswitchtomaketheinitialreset.
8.PressAUTOSTARTswitch.
9.Theinducedfanandwasteoilpumpwillstartonrunning.Atthistime,regulatethecirculatingpressureofwasteoilto0.06MPa.
10.Afterstartingthecombustionofwaistoil,regulatetheflowofwasteoilsothatthecombustionchamberoutletexhaustgastemperaturewillfallwithintherangeof900to950℃.
11.Wherewasteoilincinerationhastobeallowedtostop,pressAUTOSTOPswitch,beforestopincinerating,substitutedieseloilforwasteoil.Whenthecombustionchamberoutletexhaustgastemperaturehasarrivedat50℃,theinducedfancomestoastopautomatically.
12.Closesuchmainvalvesasatomizingairmainvalve,dieseloilvalve,etc.