3GPP TS 36214 V920 06.docx

1、3GPP TS 36214 V920 063GPP TS 36.214 V9.2.0 (2010-06)Technical Specification3rd Generation Partnership Project;Technical Specification Group Radio Access Network;Evolved Universal Terrestrial Radio Access (E-UTRA);Physical layer;Measurements(Release 9) The present document has been developed within t

2、he 3rd Generation Partnership Project (3GPP TM) and may be further elaborated for the purposes of 3GPP. The present document has not been subject to any approval process by the 3GPP Organizational Partners and shall not be implemented. This Specification is provided for future development work withi

3、n 3GPP only. The Organizational Partners accept no liability for any use of this Specification.Specifications and reports for implementation of the 3GPP TM system should be obtained via the 3GPP Organizational Partners Publications Offices.KeywordsUMTS, radio, layer13GPPPostal address3GPP support of

4、fice address650 Route des Lucioles Sophia AntipolisValbonne FranceTel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16Internethttp:/www.3gpp.orgCopyright NotificationNo part may be reproduced except as authorized by written permission.The copyright and the foregoing restriction extend to reproduction in a

5、ll media. 2010, 3GPP Organizational Partners (ARIB, ATIS, CCSA, ETSI, TTA, TTC).All rights reserved.UMTS is a Trade Mark of ETSI registered for the benefit of its members3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational PartnersLTE is a Trade Mark

6、of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational PartnersGSM and the GSM logo are registered and owned by the GSM AssociationContentsForeword 41 Scope 52 References 53 Definitions, symbols and abbreviations 63.1 Definitions 63.2 Symbols 63.3 Abbreviati

7、ons 64 Control of UE/E-UTRAN measurements 65 Measurement capabilities for E-UTRA 75.1 UE measurement capabilities 75.1.1 Reference Signal Received Power (RSRP) 75.1.2 Void 85.1.3 Reference Signal Received Quality (RSRQ) 85.1.4 UTRA FDD CPICH RSCP 85.1.5 UTRA FDD carrier RSSI 85.1.6 UTRA FDD CPICH Ec

8、/No 95.1.7 GSM carrier RSSI 95.1.8 UTRA TDD carrier RSSI 95.1.9 UTRA TDD P-CCPCH RSCP 95.1.10 CDMA2000 1x RTT Pilot Strength 95.1.11 CDMA2000 HRPD Pilot Strength 105.1.12 Reference signal time difference (RSTD) 105.1.13 UE GNSS Timing of Cell Frames for UE positioning 105.1.14 UE GNSS code measureme

9、nts 105.1.15 UE Rx Tx time difference 105.2 E-UTRAN measurement abilities 115.2.1 DL RS TX power 115.2.2 Received Interference Power 115.2.3 Thermal noise power 115.2.4 Timing advance (TADV) 125.2.5 eNB Rx Tx time difference 125.2.6 E-UTRAN GNSS Timing of Cell Frames for UE positioning 125.2.7 Angle

10、 of Arrival (AoA) 12Annex A (informative): Change history 13ForewordThis Technical Specification has been produced by the 3rd Generation Partnership Project (3GPP).The contents of the present document are subject to continuing work within the TSG and may change following formal TSG approval. Should

11、the TSG modify the contents of the present document, it will be re-released by the TSG with an identifying change of release date and an increase in version number as follows:Version x.y.zwhere:x the first digit:1 presented to TSG for information;2 presented to TSG for approval;3 or greater indicate

12、s TSG approved document under change control.Y the second digit is incremented for all changes of substance, i.e. technical enhancements, corrections, updates, etc.z the third digit is incremented when editorial only changes have been incorporated in the document.1 ScopeThe present document contains

13、 the description and definition of the measurements done at the UE and network in order to support operation in idle mode and connected mode.2 ReferencesThe following documents contain provisions which, through reference in this text, constitute provisions of the present document. References are eit

14、her specific (identified by date of publication, edition number, version number, etc.) or nonspecific. For a specific reference, subsequent revisions do not apply. For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a no

15、n-specific reference implicitly refers to the latest version of that document in the same Release as the present document.1 3GPP TR 21.905: “Vocabulary for 3GPP Specifications”.2 3GPPTS 36.201: “Evolved Universal Terrestrial Radio Access (E-UTRA); Physical Layer General Description “.3 3GPPTS 36.211

16、: “Evolved Universal Terrestrial Radio Access (E-UTRA); Physical channels and modulation”.4 3GPPTS 36.212: “Evolved Universal Terrestrial Radio Access (E-UTRA); Multiplexing and channel coding “.5 3GPPTS 36.213: “Evolved Universal Terrestrial Radio Access (E-UTRA); Physical layer procedures “.6 3GPP

17、TS 36.321: “Evolved Universal Terrestrial Radio Access (E-UTRA); Medium Access Control (MAC) protocol specification“.7 3GPPTS 36.331: “Evolved Universal Terrestrial Radio Access (E-UTRA); Radio Resource Control (RRC); Protocol specification “.8 3GPP2 CS.0005-D v1.0 “Upper Layer (Layer 3) Signaling S

18、tandard for CDMA2000 Spread Spectrum Systems Release D”.9 3GPP2 CS.0024-A v3.0 “cdma2000 High Rate Packet Data Air Interface Specification”10 3GPPTS 36.104: “Evolved Universal Terrestrial Radio Access (E-UTRA); Base Station (BS) radio transmission and reception “.11 3GPP TS 36.355: “Evolved Universa

19、l Terrestrial Radio Access (E-UTRA); LTE Positioning Protocol (LPP)”12 3GPP TS 36.455: “Evolved Universal Terrestrial Radio Access (E-UTRA); LTE Positioning Protocol A (LPPa)”3 Definitions, symbols and abbreviations3.1 DefinitionsFor the purposes of the present document, the terms and definitions gi

20、ven in TR21.9051 and the following apply. A term defined in the present document takes precedence over the definition of the same term, if any, in TR21.9051.3.2 SymbolsFor the purposes of the present document, the following symbols apply:Ec/No Received energy per chip divided by the power density in

21、 the band3.3 AbbreviationsFor the purposes of the present document, the abbreviations given in TR21.905 1 and the following apply. An abbreviation defined in the present document takes precedence over the definition of the same abbreviation, if any, in TR21.9051.1x RTT CDMA2000 1x Radio Transmission

22、 TechnologyCPICH Common Pilot ChannelE-SMLC Enhanced Serving Mobile Location CentreE-UTRA Evolved UTRAE-UTRAN Evolved UTRANFDD Frequency Division DuplexGNSS Global Navigation Satellite SystemGSM Global System for Mobile communicationHRPD CDMA2000 High Rate Packet DataP-CCPCH Primary Common Control P

23、hysical ChannelRSCP Received Signal Code PowerRSRP Reference Signal Received PowerRSRQ Reference Signal Received QualityRSSI Received Signal Strength IndicatorRSTD Reference Signal Time DifferenceTDD Time Division DuplexUTRA Universal Terrestrial Radio AccessUTRAN Universal Terrestrial Radio Access

24、Network4 Control of UE/E-UTRAN measurementsIn this chapter the general measurement control concept of the higher layers is briefly described to provide an understanding on how L1 measurements are initiated and controlled by higher layers.With the measurement specifications L1 provides measurement ca

25、pabilities for the UE and E-UTRAN. These measurements can be classified in different reported measurement types: intra-frequency, inter-frequency, inter-system, traffic volume, quality and UE internal measurements (see the RRC Protocol 7).In the L1 measurement definitions, see chapter 5, the measure

26、ments are categorised as measurements in the UE (the messages for these will be described in the MAC Protocol 6 or RRC Protocol 7 or LPP Protocol 11) or measurements in the E-UTRAN (the messages for these will be described in the Frame Protocol or LPPa Protocol 12).To initiate a specific measurement

27、, the E-UTRAN transmits a RRC connection reconfiguration message to the UE including a measurement ID and type, a command (setup, modify, release), the measurement objects, the measurement quantity, the reporting quantities and the reporting criteria (periodical/event-triggered), see 7 or E-SMLC tra

28、nsmits an LPP Request Location Information message to UE, see 11.When the reporting criteria are fulfilled the UE shall answer with a measurement report message to the E-UTRAN including the measurement ID and the results or an LPP Provide Location Information message to the E-SMLC, see 11.For idle m

29、ode, the measurement information elements are broadcast in the System Information.5 Measurement capabilities for E-UTRAIn this chapter the physical layer measurements reported to higher layers are defined.5.1 UE measurement capabilitiesThe structure of the table defining a UE measurement quantity is

30、 shown below.Column fieldCommentDefinitionContains the definition of the measurement.Applicable forStates in which state(s) it shall be possible to perform this measurement. The following terms are used in the tables:RRC_IDLE;RRC_CONNECTED;Intra-frequency appended to the RRC state: Shall be possible

31、 to perform in the corresponding RRC state on an intra-frequency cell;Inter-frequency appended to the RRC state:Shall be possible to perform in the corresponding RRC state on an inter-frequency cellInter-RAT appended to the RRC state:Shall be possible to perform in the corresponding RRC state on an inter-RAT cell.5.1.1 Reference Signal Received Power (RSRP)DefinitionReference signal received power (RSRP), is defined as the linear average over the power contributions (in W) of the resource elements that carry cell-specific reference signals within the considered measurement fre