linkproof配置步骤.docx

1、linkproof配置步骤Radware 设备配置步骤目录1 初识化配置 31.1 打开超级终端 31.2 Radware设备初始化 32 打开浏览器, 输入192.168.1.1， 然后”确定” 43 定义接口 IP 64 Routing Table 85 定义 NHR 106 SmartNAT Configuration 136.1 添加no nat 纪录 136.2 添加Dynamic NAT纪录 147 就近性配置 167.1 动态就近性配置 167.2 静态就近性配置 188 Global Configuration 211 初识化配置1.1 打开超级终端1.2 Radware设备初

2、始化（1）登录Radware设备：Login: radwarepassword : radware (2) Reboot Radware 设备：WSDreboot (3) 系统重启后，在3秒内按键盘：Press any key to stop auto-boot. 3 q (清空原有配置参数，恢复缺省值) (Reboot 设备)(4) 系统重启后， 按下列提示重新配置参数 （注：只需配置1-3项，其余各项只需敲回车键使用缺省值） 0. Exit 1. IP address 2. IP subnet mask 3. Port number 4. Default router IP address

3、 5. RIP version 6. OSPF enable 7. OSPF area ID 8. NMS IP address 9. Community name10. Configuration file name11. Username12. Password13. Web access14. Telnet access15. SSH accessEnter your choice: 1 Enter ip address: 192.168.1.1Enter your choice: 2 Enter ip subnet mask: 255.255.255.0Enter your choic

4、e: 3Enter ifIndex: 1.2 打开浏览器, 输入192.168.1.1， 然后”确定”3 定义接口 IP 打开 “RouteIP RouteInterface Parameters”，点击“Create”, 添加 IP address to interface，.4 Routing Table打开“RouteRouting Table”, 点击 “Create”icon，setup default gateway ，点击“Set”icon to save configuration. 5 定义 NHR打开 “LinkProof Next Hop RouterNext Hop R

5、outers Table”, 添加 NHRs 点击 “Set” to save configuration.6 配置链路健康检查6.1 打开高级健康检查打开 “Health Monitoring Global Parameters”, 6.2 添加检查项目打开 “Health Monitoring Check Table”, 6.3 绑定检查项目打开 “Health Monitoring Binding Table”, 7 SmartNAT Configuration7.1 添加no nat 纪录打开 “LinkProof SmartNATno NAT Table”, 添加 no NAT纪录

6、7.2 添加Dynamic NAT纪录打开 “LinkProof SmartNATDynamic NAT Table”, configure Dynamic NAT 8 就近性配置8.1 动态就近性配置打开 LinkProof Proximity Proximity Parameters general”, 8.2 静态就近性配置打开 LinkProof Proximity Static Proximity”, 点击 “Create” icon点击 “Set” icon ,保存配置9 Global Configuration打开 LinkProof Global ConfigurationClient Table”, set the Client Table to Layer 4点击 “Set” icon打开 LinkProof Global ConfigurationSmart NAT”, Enable “Smart NAT”,打开 LinkProof Global Configurationgeneral”,