1、F. send ACK 7Answer: C解释一下:201.Three access points have been installed and configured to cover a small office. What term defines the wireless topology?A. BSSB. IBSSC. ESSD. SSID202.Refer to the exhibit. Which two statements are true of the interfaces on Switch1? (Choose tow).A. Multiple devices are
2、connected directly to FastEthernet0/1.B. A hub is connected directly to FastEthernet0/5.C. FastEthernet0/1 is connected to a host with multiple network interface cards.D. FastEthernet0/5 has static ally assigned MAC addresses.E. FastEthernet0/1 is configured as a trunk link.F. Interface FastEthernet
3、0/2 has been disabled. BE203.Refer to the exhibit. The speed of all serial links is E1 and the speed of all Ethernet links is 100 Mb/s. A static route will be established on the Manchester router to direct traffic toward the Internet over the most direct path available. What configuration on the Man
4、chester router will establish a route toward the Internet for traffic that originates from workstations on the Manchester LAN?A. ip route 0.0.0.0 255.255.255.0 172.16.100.2B. ip route 0.0.0.0 0.0.0.0 128.107.1.1C. ip route 0.0.0.0 255.255.255.252 128.107.1.1D. ip route 0.0.0.0 0.0.0.0 172.16.100.1E.
5、 ip route 0.0.0.0 0.0.0.0 172.16.100.2F. ip route 0.0.0.0 255.255.255.255 172.16.100.2 E204.Refer to the exhibit. An organization connects two locations, supporting two VLANs, through two switches as shown. Inter-VLAN communication is not required. The network is working properly and there is full c
6、onnectivity. The organization needs to add additional VLANs, so it has been decided to implement VTP. Both switches are configured as VTP servers in the same VTP domain. VLANs added to Switch1 are not learned by Switch2. Based on this information and the partial configurations in the exhibit, what i
7、s the problem?A. Switch2 should be configured as a VTP client.B. VTP is Cisco proprietary and requires a different trunking encapsulation.C. A router is required to route VTP advertisements between the switches.D. STP has blocked one of the links between the switches, limiting connectivity.E. The li
8、nks between the switches are access links.205.Refer to the exhibit. What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN?(Choose two.)A. The number of collision domains would remain the same.B. The number of collision domains would decre
9、ase.C. The number of collision domains would increase.D. The number of broadcast domains would remain the same.E. The number of broadcast domains would decrease.F. The number of broadcast domains would increase. CD206.REFER TO THE EXHIBIT. Router4 can ping Router5 (172.16.6.5), but not Router7 (172.
10、16.11.7 ). There are no routing protocols running in any of the router, and Router4 has Router6 as its default gateway. What can be done to address this problem?A. Convert to static NAT.B. Convert to dynamic NAT.C. Add a static route in Router7 back to Router4.D. Change the inside and outside NAT co
11、mmands.207.Which two statements describe the Cisco implementation of VLANs? (Choose two)A. VLAN 1 is the default Ethernet VLAN.B. CDP advertisements are only sent on VLAN 1002.C. By default, the switch IP address is in VLAN 1005.D. VLANs 1002 through 1005 are automatically created and cannot be dele
12、ted.A D208.How does a DHCP server dynamically assign IP addresses to hosts?A. Addresses are permanently assigned so that the host uses the same address at all times.B. Addresses are assigned for a fixed period of time. At the end of the period, a new request for an address must be made, and another
13、address is then assigned.C. Addresses are leased to hosts. A host will usually keep the same address by periodically contacting the DHCP server to renew the lease.D. Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.209.What is the p
14、urpose of the Cisco VLAN Trunking Protocol?A. to allow traffic to be carried from multiple VLANs over a single link between switchesB. to allow native VLAN information to be carried over a trunk linkC. to allow for managing the additions, deletions, and changes of VLANs between switchesD. to provide
15、 a mechanism to manually assign VLAN membership to switch portsE. to provide a mechanism to dynamically assign VLAN membership to switch ports210.Refer to the exhibit. What statement is true of the configuration for this network?A. The configuration that is shown provides inadequate outside address
16、space for translation of the number of inside addresses that are supported.B. Because of the addressing on interface FasEthernet0/1, the Serial0/0 interface address will not support the NAT configuration as shown.C. The number 1 referred to in the ip nat inside source command references access-list
17、number 1.D. ExtemalRouter must be configured with static routes to networks 172.16.1.0/24 and 172.16.2.0/24211.212.Refer to the exhibit. The switches on a campus network have been interconnected as shown. All of the switches are running Spanning Tree Protocol with its default settings. Unusual traff
18、ic patterns are observed and it is discovered that Switch9 is the root bridge. Which change willensure that Switch1 will be selected as the root bridge instead of Switch9?213.214.Refer to the exhibit. The network manager is evaluating the efficiency of the current network design. RIPv2 is enabled on all Layer 3 devices in the network. What network devices participate in passing traffic from the PC at 10.10.1.7 to File Server at 10.20.1.6 in the order that they will forward traffic from source to destination?215.
copyright@ 2008-2022 冰豆网网站版权所有
经营许可证编号:鄂ICP备2022015515号-1