eplan+p8+214安装方法.docx
《eplan+p8+214安装方法.docx》由会员分享,可在线阅读,更多相关《eplan+p8+214安装方法.docx(12页珍藏版)》请在冰豆网上搜索。
eplan+p8+214安装方法
安装EplanP82.1.4等,必须先安装,.netFramework4,
运行一下文件,进行安装,dotNetFx40_Full_x86_x64.exe
netFramework4下载地址:
安装完后进行EplanP8等安装,使用预设进行安装
安装完进行模拟狗安装:
操作如下:
INSTALLATIONINSTRUCTIONS
1.Unzip,UnrarandrunEPLANDONGLESEmulator.exe
解压模拟狗
2.Nowyouneedtoopen"Dricer"tab,Press"INSTALL"buttonandif
installationwassuccessfulDriver
statuswindowwillbechangedto"Status:
driverisinstalled"
运行EPLAN.exe
点击驱动,安装加密狗驱动
3.Nowyouneedtoopen"Emulator"tab,Thenyoupress"StartService"
button.Ifeverythingisokyou'llsee"HASP/HARDLOCKEmulatorService
isrunning"
点击仿真
点击启动加密狗服务
4.Open"DONGLES"tabandpressthe"Loaddump"button.Loadhl5189.dng
点击,
点击加密狗,
点击加载仿真狗数据文件
选择5189.dng
5.CopySN-U10066.EGFtoC:
\DocumentsandSettings\AllUsers\ApplicationData\EPLAN\Common
复制SN-U10066.EGF到C:
\DocumentsandSettings\AllUsers\ApplicationData\EPLAN\Common
以上目录是隐藏的,需要显示出来
对于win732位
可能需要复制到:
C:
\Users\Public\EPLAN\Common如果没有的话,应该就是中文的C:
\用户\公共\EPLAN\COMMON。
以上目录是隐藏的,需要显示出来
运行Eplan
取消全部显示