天津塑力电缆手册范本.docx
《天津塑力电缆手册范本.docx》由会员分享,可在线阅读,更多相关《天津塑力电缆手册范本.docx(36页珍藏版)》请在冰豆网上搜索。
天津塑力电缆手册范本
额定电压0.6/1kV聚氯乙烯绝缘电力电缆
PVCinsulatedpowercableswithratedvoltages0.6/1kV
一、产品用途Productsapplication
本产品适用于配电网、工业装置等领域,用于固定敷设在交流50Hz、额定电压0.6/1kV的电力输配电线路上,主要功能是输送电能。
本产品为通常条件下使用的产品,不适用一些特殊条件的场合,如架空、水下、船用、海底、核电站等。
阻燃聚氯乙烯绝缘电缆适用于具有阻燃要求的场合。
耐火聚氯乙烯绝缘电缆适用于地下铁道、地下商场、大型购物中心、高层建筑等人口稠密、通风受限的场合。
Thisproductisapplicabletobeingfixedlylaidonthetransmissionanddistributionlineofalternativecurrentrating50Hzandratedvoltageupto0.6/1.0Kvwiththeuseforpowertransmission,whichisappliedtotherangeofdistributionnetwork,industrialequipments,etc.
Thisproductisthenomalusedcable,notsuitableforsomespecialplaces,suchasunderwater,ship,nuclearstation,etc.
二、产品主要技术特点Techniquefeatures
本产品电缆除具有可靠的电气性能外,还具有较强的防止化学腐蚀性,耐酸、碱和有机溶剂,电缆不受敷设落差的限制,可在任何落差甚至垂直的场合敷设。
Theproducthasgoodperformanceonelectricalcharacteristic,chemicalresistance,suchasacidresistance,alkaliresistanceandorganicsolventresistance.Theproductcanbelaidonanyheaddropconditionevenverticallyinanyplace,thatistosay,thecablecanbelaidwithoutlimitonheaddrop.
三、产品执行标准Standards7
GB/T12706.1-2002额定电压1kV(Um=1.2kV)到35kV(Um=40.5kV)挤包绝缘电力电缆及附件
第1部分:
额定电压1kV(Um=1.2kV)和3kV(Um=3.6kV)电缆
Powercableswithextrudedinsulationandtheirforratedvoltagesfrom1kV(Um=1.2kV)upto35kV(Um=40.5kV)Part 1:
Cablesforrated voltages of1kV(Um=1.2kV)and3kV(Um=3.6kV)
IEC60502-1:
1997额定电压1kV(Um=1.2kV)到30kV(Um=36kV)挤包绝缘电力电缆及附件
第2部分:
额定电压1kV(Um=1.2kV)和3kV(Um=3.6kV)电缆
Powercableswithextrudedinsulationandtheirforratedvoltagesfrom1kV(Um=1.2kV)upto35kV(Um=40.5kV)Part 1:
Cablesforrated voltages of1kV(Um=1.2kV)and3kV(Um=3.6kV)
Q/12BJ4973-2002额定电压0.6/1kV五芯塑料绝缘电力电缆
Q/12BJ4973-2002Fivecoresextrudedplasticinsulatedpowercableswithratedvoltages0.6/1kV
GB/T3956-1997电缆的导体
GB/T3956-1997ConductorofCables
GB/T19666-2005阻燃耐火电线电缆通则
GB/T19666-2005GeneralRulesofflame-retardingandfireproofcables
四、使用特性Operatingcharacteristics
1、额定电压RatedVoltage
电缆额定电压U0/U(Um)为:
0.6/1(1.2)kV
RatedVoltageofcableU0/U(Um):
0.6/1(1.2)kV
其中:
Notes:
U0:
电缆设计用的导体对地或金属屏蔽之间的额定工频电压;
RatedA.C.Voltagebetweenconductorandground/metalscreen;
U:
电缆设计用的导体间的额定工频电压;
RatedA.C.Voltagebetweenconductors
Um:
设备可承受的“最高系统电压“的最大值。
Themaximumsystemvoltagewhichtheequipmentscanbebeared
电缆的额定电压应适合电缆所在系统的运行条件。
为了便于选择电缆,将系统划分为下列三类:
Theratedvoltageofcableshallbeapplicabletosystemoperationconditionwherethecablelainin.Accordingtocableselecting,thesystemwillbedescribedas3typesasfollow:
——A类:
任一相导体与地或接地导体接触时,能在1min内与系统隔离。
SystemcategoryA—Whenanyphaseofcableconductoriscontactingwithearthconductor,thecablewillbeisolatedwiththesystem.
——B类:
可在单相接地故障时作短时运行,但任何情况下不宜超过8h,每年接地故障总持续时间不宜超过125h。
SystemcategoryB─Thesystemisallowedtorunfor8hours,whenthesingle-phaseearthfaultisexisting.Andthetotalearth-faulttimeof1yearwon'tbeabove125hours.
——C类:
包括不属于A类和B类的系统。
SystemcategoryC─TheyareincludingallsystemsbesidesAandB.
注:
在系统接地故障不能立即自动解除时,故障期间加在电缆绝缘上过高的电场强度,会在一定程度上缩短电缆寿命。
如系统预期会经常地运行在持久的接地故障状态下,该系统应划为C类。
Whenthesystemearthfaultcan'tberemovedautomatically,thelifeofcablewillbeshortenedinsomedegreebecauseoftheover-highelectricstessbearedbycableinsulation.
用于三项系统的电缆,U0的推荐值见表1。
TherecommendedfigureofU0seethetable1,whicharesuitalbeforthethreesystems.
表1额定电压U0推荐值
Table1TherecommendedfigureofU0
系统最高电压Um/kVThemaximumsystemvoltageUm/kV
额定电压/kV
RatedVoltage/kV
A类、B类
SystemcategoriesAandB
C类
SystemscategoriesC
1.2
0.6
1.2
2、导体额定工作温度
Theratedtemperatureofconductor
电缆导体的最高额定工作温度为70℃。
Themaximumassignedtemperatureofthecableconductoris70℃。
短路时(最长持续时间不超过5s)电缆导体的最高温度不超过160℃。
Duringhavingashortcircuit,lastinglessthan5seconds,themaximumtemperatureofthecableconductorshallnotbeabove160℃.
3、敷设环境温度
Ambienttemperatureforlaying
电缆敷设时的环境温度应不低于0℃,否则需要事先预热。
Theambienttemperatureforlayingshallbeabove0℃,ifnotthecableneedbepreheated.
4、安装弯曲半径
Thebendradius
安装时电缆最小弯曲半径见表2。
Theminimunbendradiusofthecableseethetable2
表2电缆安装时最小弯曲半径
Table2Theminimunbendradiusofthecable
项目
Item
单芯电缆
Single-core
三芯电缆
Three-core
无铠装
Unarmored
有铠装
Armored
无铠装
Unarmored
有铠装
Armored
安装时的电缆最小弯曲半径Minimunbendradiusofthecableincourseofinstallation
20D
15D
15D
12D
靠近连接盒和终端的电缆的最小弯曲半径
Theminimunbendradiusofthecableclosetothejunctionboxandterminal
15D
12D
12D
10D
注:
D为电缆外径(mm)。
Note:
Disouterdiameterofthecable
5、敷设方式
电缆没有敷设落差限制。
Thereisnolimitofheaddropduringthecablelaying.
电缆允许敷设在室内、室外、空气中和土壤中,允许局部有积水。
Thecablemaybelaidinindoor,outdoor,airandsoil.Thecablemaybeimmersedinwaterlocally.
电缆敷设方式可以是隧道、管道、电缆沟、桥架、排管,铠装电缆允许直埋地下,钢丝铠装电缆允许垂直敷设。
Thecablemaybelaidintunnel,